User's Manual

This setup guide provides basic instructions for assigning and using 5-Group Remote Control with Norman® motorized shade products.
For complete programing instruction, see: http://www.normanproductwarranty.com/installation-PDF-SU.asp
5-Group Remote Control / Model: RC-A01
Battery Replacement
The 5-group remote control comes with 2 CR2032 batteries included.
Please remove the protective film before use.
CAUTION : Please keep the batteries out of the reach of children 6 years old and under.
1. Unscrew the
battery cover
with screwdriver.
Back of the remote
2. Press and slide
down the cover.
3. Install batteries with
positive (+) side facing up.
CR2032 x2
+ +
4.Reinstall the
battery cover.
Button Functions
CLOSE
Move shade to
fully closed position.
Lower
OPEN
Move shade to fully open position.
Raise
Stop
Press to stop shade in any position.
: Best Privacy
: Best View
: My Favorite
Above functions will be available
after all positions of shade set up.
Shade Group 1~5
Select or unselect group
number(s) to control or setting.
ALL Shades
Select all shades.
The function of Raise & Lower buttons
may vary depending on the shade type.
Please refer to the product manual.
Product Specification
1. Model：RC-A01
2. Dimensions：L 135mm x W 50mm x H 9.3mm
3. Weight (including battery)：62g ± 5g
4. Battery / Voltage：CR2032 3V (Lithium coin battery)
5. Radio Frequency： 2.4GHz
6. Operation Temperature : 0°C - 50°C / 32°F - 122°F
版本EN- 01_page.1
Assigning Shades to Remote Group
SET
button
IMPOTANT! Please assign only one type of shades in the same group for optimal operation.
Cellular shade
1. Press shade button 3 times.
The green light will start flashing
while shade is in Pairing mode.
The example shown below is for cellular honeycomb shades.
For other products, please refer to the specific user manual.
3. Choose a desired group
The selected group number blinks.
Repeat the steps under Assigning
Shade and assign to the same group
again to remove from the group.
x3
Removing Group assignments
Follow the step above to remove the original shade assignment
first. Next, repeat the steps under Assigning Shades and choose
a different Shade Group number in step 3.
Changing Group assignments
Shade Response
Unpaired successfully
2. Hold SET button for 3 seconds
The remote will enter the Setup
mode and the group light will
start blinking.
Shade Response
Paired successfully
SET
button
Setting mode will time out
after 20 seconds of inactivity.
4. Hold SET button for 3 seconds
The remote will leave the Setup mode
and the group light will stop blinking.
FCC ID: Q3V-RC-A01
IC: 28542-RCA01
CE Information
Hereby, Nien Made Enterprise Co., Ltd.
declares that this RC-A01 is in compliance
with the essential requirements and other
relevant provisions of Radio Equipment
Regulations 2017.