User's Manual

Setup & Operation
Power ON / OFF
Pair shades with a Remote
The shades are already paired with the Remote Control, If needed, please follow the steps to re-
assign the shades to another group.
IMPOTANT! Please pair only one type of shades in the same group.
Power ON
Hold the shade button for 3 seconds and the green light will flash.
Power OFF
Hold the shade button for 3 seconds and the red light will flash.
When powered on, press the
button 3 times to enter Pairing
mode. The green light will start
flashing.
Hold SET for 3 seconds to enter
Setup mode. The Group LEDs will
start blinking.
Choose a desired group.
The selected group number
will blink.
The shade will move up and
down to indicate successful
pairing. The green light will stop
flashing.
Hold SET for 3 seconds to leave Setup
mode. The Group LEDs will stop blinking.
The device will leave Setup mode automatically
after 20 seconds of inactivity.
捲簾
圖示
捲簾
按鍵