User's Manual

go into sending a specific Device ID and Bluetooth address automatically, the work cycle is 60
minutes. Once finish one cycle then go into next same cycle, and uninterruptible power equipment
will be permanently loop cases. DA114 will not allow any Bluetooth device to match, so it will
not be any data transmission, only as a specific identifiable through the Bluetooth wireless device.
User guide
DA113 was designed for those companies which working for collecting audience rating,
Broadcasting rating, music rating, etc. Radio station and TV station need encoded Arbitron’s CBET
into their Radio and TV audio. There is a high sensitive microphone in DA113, so DA113 can
receive outside audio and decoded CBET to analysis which Radio, TV or music it is. Also DA113
will search DA114 through Bluetooth every 5min to determine whether DA113 is working at home
or not. And DA113 have an acceleration sensor to determine whether DA113 is in moving status or
not. After decode audio finished, DA113 will save current information along with current in-home
status and moving status. DA113 will report its discovery result to internet Server every day through
GPRS.
Usually, those companies need do as following:
1. With Arbitron’s assista
nce, Cooperate with Radio station, TV station, etc, to embed CBET in
the show;
2. With Arb
itron’s assistance, set one internet server and configure DA113 to enable it can
upload data to that server;
3. H
ire enough people and give everyone one set of DA113. Let them carry DA113 and collect
their hobby on Radio, TV, etc;
4. Final
ly, they can get report from server about audience rating and Broadcasting Rating;
For the employee, they need do follow that:
1. Put DA11
4 to you home power supply, so that DA114 can work constantly. DA114 will be
waiting for Bluetooth search always;
2. Charg
e DA113 to ensure it have full battery at first time. DA113 will power on and work once
it gets power supply. And DA113 only can be shutdown automatically when battery capacity
is very weak;
3. Carry
DA113 always so that it can receive what your are listening;
4. When y
ou are listening from stereo device through headphone, please connect your
headphone and personal stereo device to headphone adaptor. So that DA113 can receive the
audio;
5. Every
night please charge DA113, to ensure it has enough power;
F
CC Warning
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.