Installation Guide

NICOR, Inc. | 2200 Midtown Place NE, Albuquerque, NM 87107 | 800.821.6283 | www.nicorlighting.com | June 15, 2015 3:00 PM

INSTALLATION INSTRUCTIONS - (Continued)

0-10V Dimming Installation

After removing the top of the junction box, slide the metal separator

plate out.

Depending upon the cable gland used, (for example: Weidmueller VG

M20-1/K68) drill the appropriate sized hole in the side of the lower

j-box such that the hole in the plastic j-box coincides with one of the

holes in the aluminum heat spreader plate.

Carefully clear any drilling debris from the j-box, install the cable gland,

and pull the low-voltage, 0-10V control wiring through the cable gland

into the j-box and secure/seal the incoming cable.

Connect the 0-10V dimming control wires to those on the low-

voltage side of the LED-driver: grey to grey and purple to purple using

appropriate wire connections.

Carefully reinstall the metal separator plate into the slots on the sides of

the j-box

Now proceed to Chain/Pendant/ or Surface mounting instruction #3