Installation Guide

NICOR, Inc. | 2200 Midtown Place NE, Albuquerque, NM 87107 | 800.821.6283 | www.nicorlighting.com | June 15, 2015 3:00 PM
INSTALLATION INSTRUCTIONS - (Continued)
Pendant Mount
To pendant mount this xture either, (1) purchase an Angled Ceiling
Adaptor Kit, Wire Extension Kit & Downrod for Ceiling Fans available at
Home Center stores and install per instructions included in the Kit. Or
(2) purchase a ¾” NPT(1” outer diameter) xture conduit stem threaded
on both sides, wire of desired length and a commercial exible xture
hanger or swivel hanger.
Position the hanging pendant mounting termination at the desired
location and feed the AC supply wires through the end of the pendant.
Drill the appropriate size hole in the top of the black plastic junction
box to accommodate the pendant mounting hardware. Secure the
junction box top to the pendant mount in the desired mounting
position being sure to follow all UL, NEC, and minimum load ratings
guidelines. Use watertight connector or silicone caulking to completely
seal the pendant connection to the junction box.
Connect the xture driver AC input wires to black (line), white (neutral),
and the xture green grounding tether wire to ground using UL listed
wire connectors.
Re-install the xture to the top of the junction box with the 4 screws.
Take care to ensure all wires are inside junction box, the junction box is
seated properly on the gasket, and not to over-tighten the screws thus
cracking the plastic screw bosses.
Surface Mount
Note: Surface mounting the xture directly to a J-box will require an
appropriate gasket material (not supplied) be used between the plastic
junction box top of the xture and the AC supply J-box. Alternatively, a
bead of waterproof silicone caulking (not supplied) can be used to seal
around mating surfaces.
Hold the top of the xture junction box against the AC supply J-box in
the desired mounting position and carefully mark where to position
the mounting screws. Drill holes in the plastic xture junction box top
at the appropriate points. Secure the xture junction box top to the AC
supply J-box in the desired mounting position using the appropriate
mounting screws (not supplied) being sure to follow all UL, NEC, and
minimum load ratings guidelines.
Connect the xture driver AC input wires to black (line), white (neutral),
and the xture green grounding tether wire to ground using UL listed
wire connectors.
Re-install the xture to the top of the junction box with the 4 screws.
Take care to ensure all wires are inside junction box, the junction box is
seated properly on the gasket, and not to over-tighten the screws thus
cracking the plastic screw bosses.
3
3
4
4
5
5
6
4
3
6
Warranty
For complete warranty information please visit :
http://nicorlighting.com
Drilling
Location