Instructions / Assembly

ManualsBrandsNICOR ManualsDoorbell KitsPrimeChime Plus 2 Video Compatible Wired Door Bell Chime Kit with Architectural Bronze Stucco Button

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com May 29, 2020 4:02 PM PRCP2 Rev - Page 3 of 4

Prime Chime Plus - INSTALLATION INSTRUCTIONS Model: PRCP2

Installing multiple Prime Chime Plus (2 max, 70’ spacing to rst unit. 200’ total length)

Carefully unpack xture and faceplate.

Connect line voltage wiring (120VAC, 18ga or greater)

at each unit per the diagram.

Connect low voltage bell wires (18ga or 22ga) into the

rst unit into ports 1(+) and 2(-).

Junction

Box

Black (Line)

White (Neutral)

120V/60Hz only

Run bell wiring from ports 3(+) and 4(-) of the rst unit

into ports 1(+) and 2(-) of the next unit, max 2 units.

Leave ports 3 and 4 of the last unit open.

Note: Maintain poliarity to avoid unit damage.

1(+) to 3(+) and 2(-) to 4 (-).

See below for basic diagram of multiple chime wiring.

5 6

Attach faceplate by pressing onto chime.

Install chime into junction box using four (4) included

screws.