Instructions / Assembly

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com June 30, 2023 5:00 PM PRCP2 Rev - Page 4 of 5
7
Prime Chime Plus - INSTALLATION INSTRUCTIONS Model: PRCP2
Apply power. The button should illuminate. Test
functionality of the chime.
Note: Wiring of video doorbells is identical to standard
doorbell wiring (step 6). Please follow doorbell
manufacturer’s installation instructions for complete
information.
Warning: Continued holding or repeated pressing of
the doorbell button can cause product issues.
8
For Button Installation see steps 6-7 for single unit
installation.
Note: Wiring of video doorbells is identical to standard
doorbell wiring. Please follow doorbell manufacturer’s
installation instructions for complete information.
Installing multiple Prime Chime Plus (2 max, 70’ spacing to rst unit. 200’ total length)
Adjusting Tone and Volume
1. Indicator Light
2. Button:
• Short press: <3 seconds
• Long press: >3 seconds
START
END
Button
Operation
Button
Operation
Button
Operation
Play “Set Door Bell Volume,
Ding-Dong”
Adjust volume of chime
Exit melody selection mode
Indicator light will be OFF
Chime will play the
candidate melody
Chime will play the
candidate melody
Enter Melody Selection Mode
Indicator light will be ON
Chime will play “Set front door tone”
Conrm the front door melody
Chime will play “Set rear door tone”
Conrm the rear door melody
Short press
Short press
No operation for 20 seconds
Short press
Long press
Long press
Long press