Instructions / Assembly

ManualsBrandsNICOR ManualsDoorbell KitsPrimeChime Plus 2 Video Compatible Wired Door Bell Chime Kit with Nickel Decorative Button

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com June 30, 2023 5:00 PM PRCP2 Rev - Page 2 of 5

Prime Chime Plus - INSTALLATION INSTRUCTIONS Model: PRCP2

Apply power. The button should illuminate. Test

functionality of the chime.

Note: Wiring of video doorbells is identical to standard

doorbell wiring (step 6). Please follow doorbell

manufacturer’s installation instructions for complete

information.

Warning: Continued holding or repeated pressing of the

doorbell button can cause product issues.

Attach faceplate by pressing onto chime.

For Stucco Button:

New construction: Install mounting tube. Attach

doorbell button to chime wiring using screw terminals.

Insert button mounting springs into tube and push

against surface.

Replacement: Remove existing stucco button. Reattach

wiring to PRCP2 compatible stucco button and insert

into existing tube.

For Standard or Decorator

Buttons: Attach doorbell

button to chime wiring (18ga

or 22ga) using screw terminals

and mount doorbell button to

surface with i

ncluded screws.

Installing a single Prime Chime Plus

Connect line voltage wiring (120VAC, 18ga or greater)

per the diagram.

Install chime into junction box using four

(4) included screws.

Junction

Box

Black (Line)

White (Neutral)

120V/60Hz only

Connect low voltage bell wires (18ga or 22ga) from the included

buttons (or compatible vido doobell) into “FRONT” ports 1(+)

and 2(-) for front door and “REAR” 3(+) and 4(-) for rear door.

Front Rear