Installation Guide

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com August 29, 2017 9:00 AM rev 1.0
To avoid the risk of re, explosion, or electric shock, this product should be installed, inspected and maintained by a qualied electrician
only, in accordance with all electrical codes.
To avoid electric shock:
Be certain electrical power is OFF before and during installation and maintenance
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
Make sure the supply voltage is the same as the rated luminaire voltage
Do not install where marked operating temperatures exceed the ignition temperature of the hazardous atmosphere
Do not operate in ambient temperatures above those indicated on the luminaire nameplate
Suitable for use in the following locations:
Ambient temp: -20° ~ +40°C (-4° - 104°F)
Wet locations
What’s In The Box
One (1) Dorado
or or
Tools Needed
A screwdriver, drill, a pair of wire strippers, hex key, and 4 fasteners
appropriate for the mounting surface will be needed to install the Dorado.
Dorado - OWC
INSTALLATION INSTRUCTIONS
Models:
OWCQ4, OWCF4, OWCR4
Locate desired positioning for the xture on the
wall surface.
Carefully unpack xture from
packaging and inspect for any
damage caused in shipping.
Flip over xture and remove the mounting plate from the xture by using a hex key (⁄”) to loosen the set
screws (2), (do not remove set screws.)
Turn o power using appropriate switch/breaker.
3
1
4
2