Installation Guide

ManualsBrandsNICOR ManualsAccent LightingNUC-5 Series 12.5 in. White Selectable LED Under Cabinet Light

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com August 20, 2019 5:08 PM

What’s In The Box

One (1) NUC5

One (1) Romex Connector

ATTENTION:

• Turn power o before inspection, installation, or removal.

• Suitable for use in dry or damp indoor locations. Use only on 120 VAC, 60Hz circuits.

NUC5 Select LED Undercabinet

INSTALLATION INSTRUCTIONS

Models: NUC508S**, NUC512S**, NUC521S**,

NUC530S**, NUC540S**

Installation Steps

WARNING:

• Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.

• To prevent early failure, xture should only be installed in operating environments between -20°C and + 40°C (-4°F and 104°F)

• No user serviceable parts inside. To avoid electric shock, do not disassemble product.

• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp object

Tools & Materials Needed

This LED Undercabinet requires very few tools for

installation. A drill or a screwdriver and a pair of wire cutters will

aid in installation.

Turn o power to appropriate

circuit at the breaker box.

Insert Romex connector into the

desired knockout, install green

wire with ring end over the

connector and secure with lock

nut.

3 4

5 6

Three (3) Wire Nuts

Two (2) Mounting Screws

Pre-installed

Mount housing to desired surface

with the two captive mounting

screws (5) provided.

Note: For 40” xtures, there is an additional

mounting screw hole in the middle of

housing. Open the top cover and securely

fasten the mounting screw.

Insert supply wires through

connector and secure with the

two screws on the connector.

Using wire nuts (provided), attach black xture wire to black

supply wire, white xture wire to white supply wire, green

xture grounding lead to grounding lead. Unit is TRIAC or

ELV dimmable. Follow dimmer manufacturer instructions for

proper intsallation.

Restore power and check for proper operation.

Note:

1) On/O switch controls illumination.

2) CCT selection switch is a three-position switch that will

adjust Color Temperature between 2700K, 3000K, or 4000K.

Note: Requires 120VAC/60Hz power supply for proper operation.

Summary of content (2 pages)

PAGE 1
NUC5 Select LED Undercabinet INSTALLATION INSTRUCTIONS Models: NUC508S**, NUC512S**, NUC521S**, NUC530S**, NUC540S** WARNING: • Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing. • To prevent early failure, fixture should only be installed in operating environments between -20°C and + 40°C (-4°F and 104°F) • No user serviceable parts inside. To avoid electric shock, do not disassemble product.
PAGE 2
LED EXPRESS LIMITED WARRANTY Subject to the exclusions below, each NICOR LED product, including the LED electronics and components of a property installed NICOR LED product, will be free from defect in materials and workmanship for a period of five (5) years from the original date of purchase. The product shall be considered defective only if 10% or more of the product’s LED components fail.