Specification

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393
www.nicorlighting.com September 9, 2019 4:18 PM DLE8 Page 1 of 2
DLE8
Edge Lit Recessed LED Downlight
Type
Date
Catalog
Project
Aperture
6.4 in (163 mm)
8.9 in
(227 mm)
1.9 in
(47 mm)
7.3 in
(185 mm)
Product Description
The DLE Edge Lit LED Downlight Series oers an attractive visual aesthetic with a low prole in both
round and square apertures. The edge-lit technology uses a reective light guide panel that disperses
light through a diused lens, making it a practical and economical solution with high performance.
The ultra-thin xture depth and o-board driver allow for more exible installation and increased
lifetime with improved thermal management. The DLE xture uses a plenum-rated cable connector
to link the downlight module to the remote driver box and then pops into place with its adjustable,
spring-loaded retention tabs for a secure t, eliminating the need for a J-box or recessed housing.
Adding light in tight spaces such as hallways, bathrooms, basements, entryways, porches, stairways,
work areas, utility closets and corridors just got easier.
Construction
• Cast aluminum housing routes heat away from electrical components
• Edge-Lit technology allows for extremely thin xture depth
• Adjustable, spring loaded retention tabs ensure secure xture retention
• Certied for direct contact with insulation
• Includes gasket to meet AirTight requirements
• Suitable for damp locations
Optical System
• Precision engineered optical stack creates uniform light distribution that maximizes lumen output
• CCT oered at 2700K, 3000K, 4000K, 5000K
• Utilizes high performing LEDs with a greater than 90 CRI and an R9 greater than 50
Electrical
• O-board driver minimizes installation height and maximizes xture life through improved heat
management
• Dimmable to less than 5% with compatible TRIAC dimmers
• Operating temperature of 0° to 120°F (-18°C to 49°C)
• Input voltage of 120VAC
• TM-21 Reported L70(9K) hours >54,000
Finish
• White powder coat nish standard
Mounting and Installation
• Spring loaded retention arms allow for easy installation into ceilings up to 1 ½” thick with no need
for a recessed housing
• O-board driver/junction box includes two 1/2” KOs and three-port poke-in connectors
• Included paper cutting template
• Metal rough in template available
• Extension power cables (10’, 20’) available
Warranty
• 5-year limited system warranty
• Warranty does not cover product failure due to an overvoltage event (power surge)
• For installations where power surge may be possible, NICOR recommends installing additional
surge protection at the electrical distribution panel
5.0 in
(127mm)
1.3 in
(33 mm)
4.1 in (deep)
(104 mm)
(except 5000K)