Installation Guide

WPR LED Wrap Residential
INSTALLATION INSTRUCTIONS
Model(s): WPR-10-UNV-3K
WPR-10-UNV-4K
Risk of Fire or Shock:
Supply conductors and connectors must be rated minimum 60°C. If uncertain, consult an electrician.
CAUTION:
To avoid possible electric shock, be sure that power supply is turned o at fuse box or circuit breaker before
attempting installation or servicing of the xture. For safest operation read and become familiar with
complete installation instructions prior to use.
This luminaire must be installed in accordance with the NEC or your local electrical code. If you are not
familiar with these codes and requirements, consult a qualied electrician.
The MAXCOR™ WPR - LED Residential Wrap is
designed for surface mount applications using the
included hardware kit.
Un-pack and check for damage.
Remove cover plate of luminaire by removing the
2 screws. Save screws, as they will be used to nish
assembly.
Loosen 2 captive screws that hold driver bracket in
place. (Driver will swing out of the way).
Attach mounting bracket to junction box using the
included hardware.
Position luminaire over threaded rod.
When positioned, secure with mounting nut - ensuring
luminaire is ush to surface.
Connect line to black, neutral to white and ground
to green with supplied wire nuts.
Swing driver back into position. Be careful not to
pinch wires.
Re-secure driver to mounting plate with screws.
Re-install cover plate with 2 screws.
1
2
2
3
4
5
5
6
6
7
7
8
9
10
NICOR, Inc. | 2200 Midtown Place NE, Albuquerque, NM 87107 | 800.821.6283 | www.nicorlighting.com | rev 03.19.14
Warranty
For complete warranty information please visit :
http://nicorlighting.com/resources/warranty-info/maxcor-brand-limited-warranty
108 9
3
Black
LED Driver
Line
WhiteNeutral
GreenGround