Installation Guide

Adjust CCT or Lumen output by setting the switch positions on the back of the xture to the desired settings.
CLR Kit Installation Without Existing Frame
Make sure all power is turned o before beginning installation
Make wiring connection to junction box.
a. Connect Black wire to line wire.
b. Connect White wire to neutral wire
Identity xture location and cut rough-in hole. Cut a 5½” to
7” diameter hole for CLR6 and a 7½” to 9¼” diameter hole
for CLR8.
Fasten the LED
retrot kit MC
cable to a eld
installed j-box
(not supplied)
per local
electrical code
using a standard
MC connector
(not supplied).
4
1 2
J-Box
LINE
Black (line)
Ground
White (neutral)
Purple (dim +)
Grey (dim -)
Black (line)
Green (ground)
White (neutral)
Purple (dim +)
Grey (dim -)
CLR
CLR6 CLR8
5½” to 7” diameter
7½” to 9¼” diameter
c. Connect Green wire to ground wire
d. Route and connect Purple and Grey 0-10V dimming control wires in
accordance with dimmer instructions and electrical code.
NOTE: If 0-10V dimming is NOT to be connected, it is recommended to cut o the exposed, tinned leads on the purple and grey
wires, and cover the ends with a small piece of electrical tape or wire nut. If bare 0-10V control wires should accidentally
touch a grounded surface, it could cause unintended ickering or dimming of the light xture.
1000LM
1500LM
3000K
3500K
4000K
5000K
1500LM
2000LM
3000K
3500K
4000K
5000K
3
CLR82SWRVS9WH
CLR62SWRVS9WH
Note:
1) Power selection switch is a two-position switch that will adjust light output: low/high.
2) CCT selection switch is a four-position switch that will adjust Color Temperature between 3000K, 3500K, 4000K, or 5000K.
2000LM
3000LM
3000K
3500K
4000K
5000K
CLR82HWRVS9WH