Operating Guide

ELECTRICAL CONNECTION:
To make the electrical connections:
Connect the white wire(s) from the fixture to the white wire(s) of the supply circuit in the junction box.
Connect the black wire(s) from the fixture to the black wire(s) of the supply circuit in the junction box.
Attach the green grounding wire (or bare copper wire) from the supply circuit in the junction box to the
green grounding attachment screw on the mounting plate. To do this, simply wrap the ground wire around
the screw while tightening the screw to secure the ground wire. The ground wire from the fixture should
already be secured to this same grounding screw. Ensure that both ground wires (from the fixture and the
supply circuit) are in contact and secured by the grounding screw.
FINAL ASSEMBLY:
1. Spread the electrical wires within the junction box so that the black wires are on one side and the
white wires are on the other side.
2. Place the fixture against the junction box surface allowing the threaded hole on the mounting plate to
line up with the center hole on the fixture and secure the fixture to the mounting plate using the large
secure screw provided.
3. Install the light bulb (not included). Please refer the lamping label located within the inner spotlight
aperture. This will provide recommended maximum wattage and bulb type.
4. Outdoor wall fixtures should be caulked around the circumference of the cover plate with RTV or
silicon caulking to reduce the chance of water penetrating into the junction box. Leave the bottom
part of the cover plate clear of caulking to allow moisture a means of escape.
5. Adjust the fixture head(s) to the desired location by loosening the nut(s) on the fixture arm. Once the
head(s) are placed in the desired position, tighten the nut to secure the fixture heads in position.