Radio Shack AM/FM Portable Bluetooth Radio 1201480 User’s Manual 1
Important Safety Instructions When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture The unit should not be used near water.
unplugged from the unit to prevent damage or corrosion. 13. Servicing The user should not attempt to service the unit beyond those methods described in the user's operating instructions. Service methods not covered in the operating instructions should be referred to qualified service personnel. 14. Environment Attention should be drawn to the environment aspects of battery disposal and the use of apparatus in moderate climates. Features Thank you for purchasing the AM/FM Portable Bluetooth Radio.
Suggested that recharge the battery as soon as possible. (b) If the battery further discharges to a very low level which can not maintain the system memory , the previous settings and the unit will not operate. To resume the unit operation, you may implement the steps mentioned in the section “For the first time usage” above. For battery low status: (1) Connect an USB cable and start charging the battery. (2) The running battery symbol displays.
Side View Rear View 1. LCD display 2. TUNE +/- / button At standby mode: Set clock and 12/24 hours display format. In radio mode: Tune the radio frequency up / down. In Bluetooth mode: Skip tracks Forward / Backward. 3. POWER button Turn the unit on and off. 4. VOL +/- button Adjust volume level up and down. 5. PRESET / TIME button At standby mode: Select different setting mode (12/24 hours display format, clock). In radio mode: Enter preset radio channel mode. 6.
15. Rope holder Tight your favor hand carry rope (not included) here. Key Lock Function In order to prevent accidentally activate an undesired button operation, the model was designed with the Key-Lock function. displays. (1) To lock key, press and hold the LOCK button for few seconds until the key-lock symbol (2) To unlock key, press and hold the LOCK button for few seconds until the key-lock symbol disappears from the LCD display.
Bluetooth mode, the unit will try to connect the last connected mobile device and it will not respond to other mobile device’s connection request. If it cannot find the last device, where it will search for the other neighboring Bluetooth device. For connecting other mobile device, wait for 10 seconds after entering the Bluetooth mode. (3) Turn on the Bluetooth function of the desired mobile device and pair/connect with the main unit.
5. To select desired preset station number, press the / button from the main unit. 6. To confirm preset location, press the MEM button. 7. Repeat steps 3 to 6 to store other stations, if apply. Notes: - There is a few seconds delay when programming, after this delay time, the unit will automatically switch back to normal tuner mode. - You can overwrite a preset station by overwriting and storing the new frequency in its place. Recalling Preset Station 1. Press the POWER button to turn on the unit. 2.
Care and Maintenance - Do not subject the unit to excessive force, shock, dust or extreme temperature. - Do not tamper the internal components of the unit. - Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used. - Avoid leaving your unit in direct sunlight or in hot, humid or dusty places. - Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors.
Compliance with FCC Regulations This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
