User's Manual

13
Care and Maintenance
- Do not subject the unit to excessive force, shock, dust or extreme temperature.
- Do not tamper the internal components of the unit.
- Clean your unit with a damp (neverwet) cloth. Solvent or detergent should never be used.
- Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
- Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
Resetting the Unit
If the unit experiences a power surge or electric shock, it is possible that the internal micro-
controller may lock up and the unit will not respond to any commands from the panel controls.
1. In this event, unplug and then reconnect the power adaptor (AC main plug) into the wall
outlet.
2. Use a straightened paper clip, toothpick or similar objects to press the RESET button located
at the bottom of the main unit (see the below figure).
CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE RESET BUTTON.
IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT.
Technical Data
Power Adaptor : Input AC100V - 240V ~ 50 / 60 Hz
Output DC 12V 3000mA
Power Supply for the main unit: DC 12V 3000mA
HDMI output: 1920 x 1080p @ 60Hz
1920 x 1080i @ 60Hz
1280 x 720p @ 60Hz
720 x 480p @ 60Hz
640 x 480p @ 60Hz
Media File format supported: Photo file ----- JPG
Audio file ----- MP3
Video file ----- MP4, MOV, AVI, FLV
Note:
You may come across un-smooth pictures whilst playback some video clips in the MAP system.
Those video clips may be created from “file format converter” software program at a PC.
Because of some video files, like AVI, MOV or FLV which are the container file type format. They
can be contained different type, level and combination of audio and video format. Those files
created which may not be compatible with the MAP system. In this case you may try to adjust
parameter to an appropriate value from the “file format converter” software program during the
video clip creation/conversion. Or, try other reliable “file format converter” software.