Instructions / Assembly

INSTALLATION (Cont.)

FIG.10-1

Propanecylinde

Regulator hose assy

(coming from unit)

FIG.10-2

end to the propane cylinder and tighten (see Fig.10-1). Follow

all instructions and safety warnings supplied with the propane

cylinder.

Place the cylinder in the tank seat, and rotate the screw

clockwise to a fully stop, (see Fig.10-2).

CONNECT TO A NATURAL OR HOUSEHOLD PROPANE GAS

SUPPLY

1 . Connect a flex connector to the unit using a gas pipe

sealing compound or Teflon Tape (see Fig.10-3).

2. Bring the gas-supply pipe up from beneath the unit near its

center.

Note: Locate the gas supply line out of pathways where

people may trip over it or in areas where the line may

be subject to accidental damage.

3. Install a flare adaptor to the gas supply (NPT) using a gas

pipe sealing compound or Teflon tape (see Fig.10-3).

4. Connect the flex connector to the flare adaptor (see Fig.10-

3).

LEAK TEST

Turn on the gas supply, ignite the burner, and test at all

connections for leaks using a soapy water solution. If bubbles

appear, a leak is present . Turn off the gas and tighten at

all connections. Repeat until no leaks are present. If a leak

persists, turn off the gas supply and contact the local gas

company or dealer. NEVER USE A FLAMETO CHECK FOR

LEAKS.

*The gas hose connector shall have a connector that complies

with the Standard for Gas Hose Connectors for Portable

Outdoor Gas-Fired Appliances.

LOCATION

While following all requirements and safety information in this

manual; locate the unit on a flat, level surface.

CONNECT TO A PROPANE CYLINDER GAS SUPPLY

Important: Before installation, be sure the propane cylinder

is turned off.

Install the regulator hose assembly to the unit using a gas pipe

sealing compound or Teflon Tape. Then attach the regulator