Instructions / Assembly
15
SAFE USE & MAINTENANCE OF PROPANE GAS CYLINDERS
IMPORTANT FOR YOUR SAFETY
READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER.
When operating this applianee with a propane-gas cylinder, these instructions and warnings MUST be observed.
FAILURE TO DO SO MAY RESULT IN A SERIOUS FIRE OR EXPLOSION.
a. Propane - gas cylinder s, valve s, and hoses must be
maintained in good condition and must be replaced if there
is visible damage to either the cylinder or valve. If the hose
is cut or shows excessive abrasion or wear, it must be
replaced before using the gas appliance (see e.).
b. This unit, when used with a cylinder, should be connected
to a standard 5 - gallon (2 0 lb .) propane - gas cylinder
equipped with an OPD ( Overfill Prevention Device) . The
OPD has been required on all cylinders sold since October
1,1998, to prevent overfilling.
c. Cylinder dimension s should b e a ppr ox i m a t e l y 1 2 " (30.
5cm), in diameter and 18" (45 .7cm) high . Cylinders
must be constructed and marked in accordance with the
Specifications for Propane Gas Cylinders of the U.S.or
the National Standard of Canada, CAN/ C SA - B 3 39,
Cylinders, Spheres, and Tubes for Transportation of
Dangerous Goods.
d. The cylinder used must in elude a collar to protect the
cylinder valve, and the cylinder supply system must be
arranged for vapor withdrawal.
e. The pressure regulator and hose assembly (Fig.7-1) supplied
with this outdoor gas appliance must be used. Original and
replacement pressure regulator and hose assemblies must
be those specified by the manufacturer for connection
with a cylinder connecting device identified as Type I by
the ANSI Z21.58-2005/CGA 1.6-2005 (see PARTS LIST for
ordering information).
f. The propane- gas cylinder valve must be equipped with a
cylinder connection coupling device, described as Type I
in the standard defined in paragraph e. above. This device
is commonly described as an Acme thread quick coupler.
g. If the propane-gas cylinder comes with a dust plug, place
the dust cap on the cylinder valve outlet when ever the
cylinder is not in use.
QUICK COUPLER OPERATION
To connect the regulator/ hose assembly to the propane-
gas cylinder valve fitting: Press the hand nut on the regulator
over the Acme thread fitting on the cylinder valve. Turn the
hand nut clockwise to engage the threads and tighten until
snug. The use of pliers or a wrench should not be necessary.
Only cylinders marked “propane” may be used.
To disconnect: Turn the hand nut counterclockwise until
detached (Fig.7-1).
Important: Before using the unit, and after each time the
cylinder is removed and reattached, check the
hose for wear (see a.) and check all connections
for leaks. Turn off the unit valves and open the
main cylinder valve, then check connections with
soapy water. Repair any leaks before lighting the
unit.
CAUTION: Always turn the propane cylinder main valve
off after each use, and before moving the unit
and cylinder or disconnecting the coupling .
This valve must remain closed and the cylinder
disconnected while the appliance is not in use,
even though the gas flow is stopped by a safety
feature when the coupler is disconnected.
Carefully inspect the hose assembly each time before the
gas is turned on. A cracked or frayed hose should be replaced
immediately.
If the appliance is stored in doors, the cylinder must be
disconnected and removed. Disconnected cylinders must
be stored outdoors, out of the reach of children, with
threaded valve plugs tightly installed, and must not be
stored in a building, garage, or any other enclosed area.
FOR YOUR SAFETY
a. DO NOT store a spare propane-gas cylinder under or near
this appliance.
b. NEVER fill the cylinder beyond 80-percent full.
c. IFTHE INFORMATION IN a. AND b. IS NOT FOLLOWED
EXACTLY, A FIRE CAUSING DEATH OR SERIOUS INJURY
MAY OCCUR.
Fig. 7-1 Type I Acme thread quick coupler
Handwheel Brass Acme
thread fitting
QCC Type 1
valve
U
L
Liquid levol
indicator
(optional)
Hand nut whAc me threod
Hose
Pressure
relief
valve
Venl
CYLINDER/CONNECTOR REQUIREMENTS
Regulator