Instructions / Assembly

OPERATIONCHECKLIST
12
Operation Checklist
For a safe and pleasurable heating experience, perform this check before each use.
Before Operating
1. I am familiar with entire owner's manual and understand all precautions noted.
2. All components are properly assembled, intact and operable.
3. No alterations have been made
4. All gas connections are secure and do not leak.
5. Wind velocity is below 10mph.
6. Unit will operate at reduced efficiency below 40°F / 4.44°C
7. Fire pit is outdoors(outside any enclosure)
8 . There is adequate fresh air ventilation. Do not use this appliance if any part has been underwater. Immediately call aquali
ed service technician to inspect the appliance and to replace any part of the control system and gas control which has been
underwater.
9. Fire pit is away from gasoline or other flammable liquids or vapors
10. Fire pit is away from windows air intake openings, sprinklers and other water sources.
11. Fire pit is at least 36in.on rear and at least 36in.on sides from combustible materials.
12. Fire pit is on a hard and level surface.
13. There are no signs of spider or insect nests.
14. All burner passages are clear.
15. All air circulation passages are clear.
1 6. Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or
clothing ignition.
17. Young children should be carefully supervised when they are in the area of the fire pit.
18. Clothing or other protective material should not be hung from the fire pit, or place donor near the fire pit.
19. Any guard or other protective device removed for servicing the fire pit must be replaced prior to operating the fire pit.
2 0. Installation and repair should be done by a qualified service person. The fire pit should be inspected before use and at
least annually by a qualified service person.
2 1 . More frequent cleaning maybe required as necessary, It is imperative that control compartment, burner and circulating air
passageways of the fire pit be kept clean.
After Operation
1. Gas control is in OFF position.
2. Gas Tank valve is OFF.
3. Disconnect Gas line.
4. After each use, replace capon tank
OPERATIONCHECKLIST
Before beginning assembly of product, make sure all parts are present Compare parts with package contents list and hardware
contents above. If any part is missing or damaged, do not attempt to assemble the product Contact customer service for
replacement parts.
Estimated Assembly Time: 15 Minutes
Tools Required for Assembly(not included):
Phillps screwdriver w/medium blade.Leak Detection Solution.