Specifications

www.nicerf.com RF4463PRO
NiceRF Wireless Technology LTD. Rev 2.3
[e-mail]
‐ 10 ‐
board, user can use oscilloscope, multi‐meter to monitor the operation of the RF module, which is
very useful for software programming.

Working Mode
There are 5 working modes in the DEMO. They are: Master mode, Slave mode, Tx Test
mode, Rx test mode, Standby mode, accordingly, they are displayed on the LCD as: Tx
normal / Rx normal / Tx Test / Rx test / Standby. When one packet is transmitted, the Red
LED will blink once, the number of Tx packets will increase; when one packet is received,
the Blue LED will blink once, the number of Rx packets will increase.
1) Master Mode: Send 1 packet per second, and waiting for the acknowledge;
2) Slave Mode: Stay in Rx mode to wait for the data from the master, it will send back the
acknowledged signal after received the data from the master.
3) Tx Test Mode: RF module continuously transmit signal;
4) Rx Test Mode: RF module is always in Rx mode;
5) Standby Mode: RF module is always in standby state.

Button Operation
1) [SET] Button
Press the [SET] button to enter setting mode if not in setting mode. In setting mode,
press [SET] button to toggle between the set parameters: frequency /output power /
data rate / working mode. The related LCD ICON will flash to indicate.
2) [UP] Button
In setting mode, press the [UP] button to increase the value of flash icon.
3) [Down] Button
In setting mode, press the [Down] button to decrease the value of flash icon.
Note: The DEMO board has FLASH memory inside, all the setting parameters will be
saved automatically and keep unchanged even power‐off.