User's Manual
Table Of Contents
This device is intended only for OEM integrators under the following conditions:
1) Theantennamustbeinstalledsuchthat20cmismaintainedbetweentheantennaandusers,
and
2) Thisdeviceanditsantenna(s)mustnotbeco‐locatedwithanyothertransmittersexceptin
accordancewithFCCmulti‐transmitterproductprocedures.Referringtothemulti‐transmitter
policy,multiple‐transmitter(s)andmodule(s)ca
nbeoperatedsimultaneouslywithoutC2P.
3) ForallproductsmarketinUS,OEMhastolimittheoperationchannelsinCH00toCH80for
2.4Gbandbysuppliedfirmwareprogrammingtool.OEMshallnotsupplyanytoolorinfotothe
end‐userregardingtoRegulatoryDomainchange.
USER
SMANUALOFTHEENDPRODUCT:
Intheusersmanualoftheend product,theenduser has tobeinformedtokeepatleast20cm
separationwiththeantennawhilethisendproductisinstalledandoperated.Theenduserhasto
beinformedthat the FCC radio‐frequencyexposure guidelinesfo
ran uncontrolledenvironment
can be satisfied. The end user has to also be informed that any changes or modifications not
expressly approved by the manufacturer could void the user's authority to operate this
equipment.Ifthesizeoftheendproductissmallerthan8x10cm,thenadditionalFCCpart15
.19
statement is required to be available in the users manual: This device complies with Part 15 of
FCC rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference and (2) this device must accept any interference received, including
interferencethatmaycauseundesir
edoperation.
LABELOFTHEENDPRODUCT:
The final end product must be labeled in a visible area with the following " ContainsFCC ID:
2AD66‐R
F2401PRO".Ifthesizeoftheendproductislargerthan8x10cm,thenthefollowingFCC
part15.19statementhastoalsobeavailableonthelabel:ThisdevicecomplieswithPart15of
FCC rules. Operation is subject to the following two conditions: (1) this device may not ca
use
harmful interference and (2) this device must accept any interference received, including
interferencethatmaycauseundesiredoperation.