User Manual
12
USB FLASH DRIVE
After inserting a USB ash drive, press button (2) and the USB mode will be announced
by an audio signal.
For both the SD card and USB ash drive, play or pause tracks by pressing button (5).
Press and hold the volume controls, located on buttons (4) and (6) to change the volume.
Press the volume up button to jump to the next track and the volume down button to
jump to the previously played track. The device supports a maximum data capacity of
32GB and the following audio formats: MP3, WMA, WAV, APE, FLAC.
TELEPHONE CALLS
Press button (5) to accept and then end telephone calls. Press and hold the same button
to decline a telephone call. Press the same button twice to call the last number in your
call list.
MAGIC BUTTON
Press button (1) to switch between the two audio modes. The reinforced bass mode has
been activated when the button is backlit.
Note: You will need to keep in mind that the Magic Button mode uses up more of the
battery life.
FACTORY SETTINGS
Should you encounter technical diculties, return the speaker to its factory settings. The
speaker must be powered on. Insert any thin object (needle, pin) into the reset opening
(7). The speaker will automatically power o. Manually power the speaker back on to
complete the reset process.