User Manual

23
QUICK SETUP
1. Before activating the accessory, please make sure you
have the Niceboy ION app downloaded and Niceboy
ION ORBIS Bridge installed.
2. Insert the battery inside the sensor unit (CR2 type).
Then hold the reset button for 5 seconds until the
indicator light starts ashing rapidly.
3. There are two methods to add the device
a. Open the Niceboy ION app, tap “Home” and then
open Niceboy ION ORBIS Bridge. Click on „Zigbee
devices list“, then on „Add device“ and then on „Add
new devices“. The app will start looking for nearby
devices. Once the device is found, it will appear on the
screen. Click on the device and add it to your app.
b. Open the Niceboy ION app, and then tap “+” in the
top right corner to enter “Add Device page“. Select
“Sensors”, then click on „Motion sensor“ and choose
the Zigbee gateway (Niceboy ION ORBIS Bridge). Con-
rm that you inserted batteries, reseted the device
and that the light indicator is blinking rapidly (step 2).
The app will start looking for a new device. Once the