User Manual

To switch them o, simply insert the earphones into the charging box. They will turn

themselves o and disconnect from your device. The earphones are stored correctly

in the box when the LED (1) turns orange. When the earphones are fully charged,

the LED goes out. To switch the earphones o, press and hold both multifunction

buttons (2) for approx. 12 seconds.

MULTIFUNCTION BUTTON - BASIC OPERATION

Press any button once - play/pause, answer/hang up

Press and hold the right button - increase the volume, reject the call

Press and hold the left button - decrease the volume, reject the call

Press the right button twice - next song

Press the left button twice - previous song

Press any button three times - activate Siri / Google Assistant

Press any button four times - change mode in the following order: ANC on / Ambient

/ ANC o

CHARGING:

To charge the box itself, connect the charging cable to the USB-C port (5). During

charging, the LED indicators (4) will start ashing; when fully charged they will turn

light blue.

FACTORY SETTINGS:

In case of technical problems, reset the earphones to the factory settings as follows:

1. Remove the earphones from the Bluetooth list on your device.

2. Remove the earphones from the charging box.

3. Switch both earphones o by pressing and holding the multifunction buttons (2)

for approx. 12 seconds.

4. Press and hold the multifunction buttons to switch both earphones on.

5. Press both multifunction buttons four times simultaneously - the earphones will

switch o.