Installation Instructions

4 – ENGLISH
MEMORISING THE TRANSMITTER
3
3 MEMORISING THE TRANSMITTER
3.1 TRANSMITTER VERIFICATION
Before memorising the transmitter in the automation’s receiver, en-
sure that it is working correctly by pressing any button while observing
whether LED (A) lights up.
If LED (A) fails to light up, check the condition of the battery and re
-
place it if necessary (refer to the “REPLACING THE BATTERY” par-
agraph on page 6).
A
3
3.2 MEMORISING THE TRANSMITTER
To memorise the transmitter in a receiver, the following procedures can
be adopted:
– memorisation in “Mode 1”
– memorisation in “Mode 2”
– memorisation in “Extended Mode 2”
– memorisation through the “Enabling Code” received from a previ
-
ously memorised transmitter.
l
These procedures are described in the instruction
manual of the receiver or control unit with which
the transmitter must be operated. The above-men-
tioned manuals are also available on the website:
www.niceforyou.com.
3.2.1 MEMORISATION IN “MODE 1”
This mode allows for memorising in the receiver, once only, all the
transmitter command buttons, associating them automatically with
each command managed from the control unit (default commands).
l
Refer to the control unit instructions to identify the
type of command that will be paired with each trans-
mitter button.
3.2.2 MEMORISATION IN “MODE 2”
Allows for memorising in the receiver a single transmitter button, asso-
ciating it with the commands managed from the control unit (maximum
4, chosen by the user).
l
The same procedure must be repeated for each button
to be memorised.
3.2.3 MEMORISATION IN “EXTENDED MODE 2”
This procedure is the same as the memorisation in “Mode 2”, with
the added possibility of choosing the desired command (to be paired
with the button being memorised) in an extended list of commands
managed from the control unit (up to 15 different commands).
l
Refer to the control unit instructions to identify the ex-
tended list of commands.
3.2.4 MEMORISATION THROUGH THE “ENABLING CODE”
(BETWEEN AN OLD TRANSMITTER ALREADY
MEMORISED AND A NEW TRANSMITTER)
The MYGO (MYGO/A) transmitter has a secret code, the so-called
“ENABLING CODE”. By transferring this code from a memorised
transmitter to a new transmitter, the latter is recognised (and memo
-
rised) automatically by the receiver.
l
In the MYGO8 (MYGO8/A) model, consider keypad di-
vided into 2 sectors: sector (D) on the left and sector
(E) on the right. Each sector can be regarded as if it
were an independent transmitter. In the operations de-
scribed below, refer to the buttons situated within the
sector to be memorised.
5
1
2
3
4
6
7
8
ED
4
To perform the memorisation procedure:
1. Draw the two transmitters, NEW and OLD, near to one another,
as shown in “Figure 5”.
Old New
5
2. On the NEW transmitter, press and hold any button, within the
desired sector, until LED (A) of the OLD transmitter switches on.
Subsequently, release the button (LED (A) of the OLD transmit
-
ter will start ashing).
Old New
A
6