Nice MYGO MYGO/A One-way transmitters EN - Instructions and warnings for installation and use MYGO4 MYGO4/A 1 5 2 6 3 7 4 8 MYGO8 MYGO8/A
ENGLISH Translation of the original instructions in full 1 GENERAL SAFETY WARNINGS AND PRECAUTIONS . . . . . 2 PRODUCT DESCRIPTION AND INTENDED USE . . . . . . . . . 3 3 MEMORISING THE TRANSMITTER . . . . . . . . . . . . . . . . . . . 4 4 5 6 ENCODING SWITCH PROCEDURE . . . . . . . . . . . . . . . . . . . . 5 REPLACING THE BATTERY . . . . . . . . . . . . . . . . . . . . . . . . . . 6 PRODUCT DISPOSAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 7 8 TECHNICAL SPECIFICATIONS .
2 2 PRODUCT DESCRIPTION AND INTENDED USE PRODUCT DESCRIPTION AND INTENDED USE Transmitters of the series MYGO (MYGO/A) are designed to control automations (gates, garage doors, road barriers and similar). a CAUTION! – Any use other than that specified herein or in environmental conditions other than those stated in this manual is to be considered improper and is strictly forbidden! 2.1 LIST OF CONSTITUENT PARTS “Figure 1” shows the main parts making up MYGO (MYGO/A) transmitters.
3 3 MEMORISING THE TRANSMITTER MEMORISING THE TRANSMITTER 3.1 TRANSMITTER VERIFICATION Before memorising the transmitter in the automation’s receiver, ensure that it is working correctly by pressing any button while observing whether LED (A) lights up. If LED (A) fails to light up, check the condition of the battery and replace it if necessary (refer to the “REPLACING THE BATTERY” paragraph on page 6). 3.2.
3. On the OLD transmitter, press and hold any button, within the desired sector, until LED (B) of the NEW transmitter switches on. Subsequently, release the button (LED (B) of the NEW transmitter will turn off to signal that the procedure has terminated and the “enabling code” of the NEW transmitter has been transferred). 7 A Old New 4 4 ENCODING SWITCH PROCEDURE ENCODING SWITCH PROCEDURE MYGO (MYGO/A) transmitters operate by default with the one-way “O-Code” (“O-Code/A”) radio encoding system.
5 REPLACING THE BATTERY 6 When the battery is flat and a button is pressed, the corresponding signalling LED fades and the transmitter will not transmit. With the battery almost flat, the signalling LED emits red flashes during the transmission process. To restore normal transmitter operation, replace the battery with a version of the same type, while observing the polarity. To change the battery: 1. insert a hairpin (or similar object) through hole (A) to unlock the shell (B) and remove it 2.
7 9 TECHNICAL SPECIFICATIONS TECHNICAL SPECIFICATIONS l l 9 All technical specifications stated in this section refer to an ambient temperature of 20°C (± 5°C). Nice S.p.A. reserves the right to apply modifications to the product at any time when deemed necessary, without altering its functions and intended use. The range of transmitters and the reception capacity of the receivers are heavily affected by other devices (alarms, headphones, etc.) operating on the same frequency in your area.
IS0807A00EN_12-01-2022 Nice SpA Via Callalta, 1 31046 Oderzo TV Italy info@niceforyou.com www.niceforyou.
