Installation Instructions

19 – English
C.2 - Memorising ANOTHER TRANSMITTER (second, third, etc.)
NOTES AND WARNINGS
• To run procedures C.2.1.A and C.2.2.A, you must have a new transmitter to memorise and an old previously memorised transmitter. The two transmitters must
have the “PRG” and “ESC” buttons (like “ERA P” and “ERA W” transmitters).
• To run procedures C.2.1.B and C.2.2.B you must have a new transmitter to memorise, chosen from the “Nice Screen” catalogue , and an old previously memorised
transmitter.
C.2.1 - To memorise the transmitter buttons in “Mode I” (“Standard mode”)
• Procedures C.2.1A and C.2.1.B memorise all the new transmitter’s buttons in “Mode I”, with the same configuration as the old transmitter (for details about “Mode
I” see par. 4.5.1).
C.2.1.A - Procedure for transmitters equipped with the “PRG” and “ESC” buttons (“ERA P” and “ERA W”)
1
 2
OLD
PRG
...
2
1
sec.
2
PRG
On the OLD transmitter: hold down the
button and
wait ... count 2 movements; wait again... count 2 more move-
ments;
release the button.
2 3
end
NEW
PRG
= 5 sec
PRG
2
OLD
PRG
(x 1)
3
On the NEW transmitter: hold down
the button and
release it after 5
seconds;
count 2 movements. On the OLD transmitter: press and
release the button (1 time);
count 3 movements (= transmitter
memorised). If the system makes 6
movements (= memory locked or full,
transmitter not memorised).
C.2.1.B - Procedure for transmitters without the “PRG” and “ESC” buttons”
1 2
 3
NEW
= 8 sec
OLD
(x 3)
On the NEW transmitter: hold down the but-
ton and
release it after 8 seconds; On the OLD transmitter: press and release the but-
ton (3 times), provided the button is memorised.
3
end
NEW
(x 1)
3
On the NEW transmitter: press and
release the button (1 time);
count 3 movements (= transmitter memorised). If
the system makes 6 movements (= memory locked or
full, transmitter not memorised).
C.2.2 - To memorise the transmitter buttons in “Mode II” (“Custom mode”)
• Procedures C.2.2A and C.2.2.B memorise a single button on the new transmitter in Mode II; i.e. they associate with the button (chosen by the installer) one of the
commands in the motor’s “list of commands” (for details on “Mode II” see section 4.5.1).
• Procedures C.2.2A and C.2.2.B memorise a single button. Repeat this operation to memorise another button.
C.2.2.A - Procedure for transmitters equipped with the “PRG” and “ESC” buttons (“ERA P” and “ERA W”)
C