Installation Instructions

English – 16
–– GROUP “B” PROCEDURES ––
for motors configured for TWO-WAY communications
Procedures which can only be completed with a Nice “ERA P” or “ERA W” transmitter with the s, n, t, PRG, ESC keysv
GENERAL WARNINGS RELATING TO THE PROCEDURES
• Before starting any programming, move the awning to an intermediate position, away from the Up and Down limit switch-
es.
• If the programming transmitter controls multiple groups of screen motors, before sending a command requested by
the procedure, select the group to which the motor being programmed belongs.
• When the motor is powered up, if it makes 2 movements this means that: at least one transmitter has been memorised
and no limit switch has been programmed; if, on the other hand, it makes 1 movement this means that: no transmitter
has been memorised.
• When running a procedure, you can abort the procedure at any time by pressing ESC (on the back of the transmitter).
• When the Up and Down limit switches are not programmed, the awning can only be commanded in hold-to-run mode -
i.e. you must hold the button down until the awning reaches the desired position. The movement stops when you release
the button in any position.
• When the Up and Down limit switches have been programmed , the awning can be controlled by simply pressing and
releasing the buttons. Doing so starts the movement, which is stopped automatically by the system when the awning
reaches the programmed position.
• All procedures require you to use a transmitter memorised in “Mode I” (e.g., memorised with procedure A.1 or with pro-
cedure B.1).
B.1 - Memorising ANOTHER TRANSMITTER (second, third, etc.)
NOTES AND WARNINGS
• To run procedures B.1 you must have a new transmitter to memorise and an old previously memorised transmitter. The two transmitters must have the “PRG” and
“ESC” buttons (like “ERA P” and “ERA W” transmitters).
• Procedures B,1 memorise all the new transmitter’s buttons in “Mode I”, with the same configuration as the old transmitter (for details about “Mode I” see par. 4.5.1).
Procedure for transmitters equipped with the “PRG” and “ESC” buttons (“ERA P” and “ERA W”)
1 2 3
 4
OLD
PRG
NEW
(x 1)
2
OLD
PRG
PRG
On the OLD transmitter: press
and hold key
For a NEW transmitter: press
the key
count 2 movements; On the OLD transmitter: release
the button
press and hold key
4
fine
NEW
(x 1)
3
On the NEW transmitter: press
the button
count 3 movements (= transmit-
ter memorised).
B