Datasheet

Construction manual for robot kit NIBObee 01.12.2014
Now the two long cable straps have to be shortened to 10 cm each (cut off at
the correct side!) and they must be slightly formed as shown in the pictures.
The enclosed heat-shrinkable tubing must be divided into two similar halves:
The pieces of heat-shrinkable tubing must be pushed over the oblong
supporting circuit boards and then they are fixed by shrinking with the
soldering iron. The left feeler should be left-facing and the right one should
be right-facing.
While shrinking the soldering iron should have at least 3 mm distance to the
heat-shrinkable tubing.
http://nibobee.nicai-systems.de 44