Datasheet

Construction manual for robot kit NIBObee 01.12.2014
2.5.4 Assembling of the feelers
Now the both oblong supporting circuit boards have to be prepared. Cut the
silver wire into two similar halves and put each one through the boards as
shown below. Then the wire has to be bent over at both sides:
The wire must be soldered to the contacts of the board on both sides. Then it
has to be put through the boreholes of the main circuit board:
At the bottom side the wire must be fixed with the small square supporting
circuit boards. First put the wire through the boards and then fix it by
soldering:
Finally the spare wire has to be cut.
http://nibobee.nicai-systems.de 43