Datasheet

Construction manual for robot kit NIBObee 01.12.2014

2.5.3 Assembling of the sensor boards

The sensor circuit boards  and  must be put into the main circuit board.

For easy assemblation you take the board a little bit sloped and put the front

side first through the main board. The boards are not soldered yet!

The board  is labeled with “LEFT” and must be put into the slot LEFT. The

board  has to be put into the right side.

Now the board  must be pressed on from the bottom side. Therefore you

hold the boards  and , turn the main circuit board and press the board 

on so that you can see the electronic parts of the board .

Pay attention to the orientation!

The circuit boards are labeled with R and L:

http://nibobee.nicai-systems.de 41