Datasheet

Construction manual for robot kit NIBObee 01.12.2014
Now the left side of the transmission unit has to be assembled:
Put the white plastic distance ring to the short axis with the red gearwheel (to
the opposite side of the little gearwheel). Then the axis must be put (with the
distance ring ahead) into the borehole below the photo-transistor PT1.
Afterwards you have to put the long axis with the white gearwheel (the little
gearwheel outwards) into the lower borehole:
The transmission is fixed by the board (the electronic parts of the board 
point inwards). Finally the covering plate is pressed onto the boards  and 
with careful pressure (see image).
From the outside the boards have to be soldered at four points:
http://nibobee.nicai-systems.de 38