Datasheet

Construction manual for robot kit NIBObee 01.12.2014
2.5.2 Assembling of the engine section / transmission unit
Now the two motors and the circuit boards  and  have to be fixed to
the main circuit board.
First of all put the motor axis through the boards as shown below. The
soldering contacts of the motors must point downward.
In case of one motor does not fit correctly into the hole, the hole can be
carefully widened with a 6mm drill bit.
We start with the left side (to driving direction):
Put the board through the fitting slots of the main circuit board so that the
motor will be planar onto the “MOTOR LEFT” field.
The soldering contacts of the motor have to fit exactly into the recess of the
main circuit board:
http://nibobee.nicai-systems.de 35