Datasheet

Construction manual for robot kit NIBObee 01.12.2014
2.5 Assembling of the modules
2.5.1 Preparatory operations
The two red double gearwheels must be pressed onto the two short steel
axes (3x20 mm). Therefore you have to press the axis with the help of a small
hammer into the side of the gearwheel with the smaller gear:
Then you have to press the axis carefully with the small hammer through the
gear. Afterwards the gearwheel should be in the middle of the axis:
Tip: This works easier e.g. with the help of a table edge:
http://nibobee.nicai-systems.de 33