Datasheet

Construction manual for robot kit NIBObee 01.12.2014
The sequence of placement depends on the height of the components to
make all soldering pads well accessible. The following subsections are sorted
according to this criterion.
Information: All circuit boards (-) are assembled in this chapter.
2.3.1 Resistors
The resistors are soldered horizontal onto the boards.
You don't have to pay attention to the polarity. The legs
must be bent over, as shown in the illustration.
The value of the resistors is indicated by a four band
colour code on the resistor, which is explained in the
appendix.
The following table shows the colour codes of the used resistors:
value parts colour code
3,3 Ω R9, R13, R20, R21, R22 orange – orange – gold - (gold)
68 Ω R12, R14 blue – grey – black - (gold)
120 Ω R16, R17, R18, R27,
R28, R36
brown – red – brown – (gold)
180 Ω R23, R26, R32, R33,
R39, R40, R41, R42,
R46, R47, R48, R49, R50
brown – grey – brown – (gold)
820 Ω R1, R2, R3, R4, R5, R6,
R7, R8, R24, R30, R31,
R53
grey – red – brown – (gold)
2,2 kΩ R15, R34, R37, R38 red – red – red – (gold)
4,7 kΩ R10, R11, R51, R52 yellow – violet – red – (gold)
47 kΩ R19, R25, R35, R43,
R44, R45
yellow – violet – orange – (gold)
Tip: There is an overview of the placement of all resistors on the next pages!
http://nibobee.nicai-systems.de 20