Datasheet

Construction manual - Robot kit NIBO burger 08.09.2015
2.3.9.5 Jumper 2-pole
The best way to place the
jumper J5 and J6 onto the
board is to solder them
complete (connector and
bridge). You should pay
attention to a short
soldering time so that the plastic does not
melt.
J6 is to find on board , it's the motor jumper. The motor function is only
active with connected J6. Therefore we take off the bridge after soldering to
deactivate the motor function!
J5 is to find on board , it's the LED jumper. If J5 is not connected, the leds
LED1-LED4 are deactivated. Than you are free to use the port bits of these
leds at X11 and X12.
After soldering we connect J5 with the bridge!
2.3.9.6 Jumper 3-pole
The 3-pole jumpers J1, J2,
and J3 have to be soldered
analog to the 2-pole ones.
After soldering the jumpers
must be connected at the
RUN position.
2.3.9.7 Button
The placement of the buttons
SW1 - SW3 is protected against
polarity reversal. You have to
place it onto the board with soft
pressure till it snaps in.
You don't have to pay attention to
the polarity.
http://nibo.nicai-systems.de 50
Type Part
Jumper J5
J6
type part
Jumper JP1
JP2
JP3
Type Part
Jumper J1
J2
J3
Type Part
Button SW1
SW2
SW3