Datasheet

Construction manual - Robot kit NIBO burger 08.09.2015
2.3.8.1 IC-Sockets
There are four IC-sockets
to be soldered onto the
boards. The 40 pin socket
is for the main controller
ATmega16, the 14 pin
socket is for the ATtiny44,
the 16 pin socket is for the demultiplexer
74HC139 and the 8 pin one is for the
operational amplifier LM358.
The notch in the socket must
point in the same direction as
the mark on the board!!
The ICs will be inserted later!
2.3.8.2 Voltage controller IC
The 3,3 V voltage
controller IC must be
placed onto board 
into the soldering pad
IC3.
Therefore the middle leg of the
component has to be bent a little bit.
Note: The component is NOT to be flush mounted onto the board. It should
stick out circa 2 mm:
During placement you have to pay
attention to the polarity! The flat
side of the component is marked on
the circuit board.
http://nibo.nicai-systems.de 47
Type Part
40-pol
16-pol
14-pol
8-pol
IC1
IC2
IC5
IC4
Type Part
TSC
295033
IC3