Datasheet

Construction manual - Robot kit NIBO burger 08.09.2015
2.3.5 Component placement of boards  and 
Now we place components onto the both main circuit boards:
Note: The sequence of placement depends on the height of the components
to make all soldering pads well accessible. The following subsections are
sorted according to this criterion.
2.3.5.1 Resistors
The resistors are soldered horizontal onto the
boards. The legs must be bent over, as shown in the
illustration.
You don't have to pay attention to the polarity.
The value of the resistors is indicated by a four band
colour code on the resistor, which is explained in the
appendix.
R1 – R16 are on board , R20 – R48 are on board 
Value Parts Colour code
3,3 Ω R1, R16, R40, R41, R42 orange – orange – gold - (gold)
68 Ω R24, R25 blue – grey – black - (gold)
120 Ω R13, R14, R30, R35, R36 brown – red – brown – (gold)
180 Ω R20, R21, R28, R29 brown – grey – brown – (gold)
820 Ω R4, R5, R6, R7, R8, R9,
R10, R11, R38, R46, R47
grey – red – brown – (gold)
4,7 kΩ R2, R3, R22, R23, R31,
R32, R33, R34, R37,
R39, R43, R44, R45
yellow – violet – red – (gold)
47 kΩ R12, R15, R26, R27, R48 yellow – violet – orange – (gold)
Tip: There is an overview of the placement on the next pages!
http://nibo.nicai-systems.de 42