Datasheet

Construction manual - Robot kit NIBO burger 08.09.2015
The resistors with the value 180 Ω
(code: brown-grey-brown- (gold))
have to be placed to the soldering pads R55 and
R56 on the bottom sides of the boards.
Each board gets one IR led. They have to be placed
into the marked soldering pads (see the photos).
You have to pay attention to the polarity:
The short leg must be placed into the rectangular
soldering pad!
Finally four 5-pin straight headers are placed into the
soldering pads J1.A, J2.A, J3.A and J4.A from the
bottom sides of the boards and are soldered from the
top sides.
http://nibo.nicai-systems.de 37