Datasheet

Construction manual - Robot kit NIBO burger 08.09.2015
Now you have to heat the soldering pad and the leg simultaneously with
the soldering iron at the bottom side of the board:
Then the tin-solder has to be attached additionally. If everything is well
heated, the tin-solder is melting and the leg of the electronic part gets
connected to the soldering pad:
The finished soldering point should look like this:
The leg of the electronic part has to be fixed at the soldering pad. If it is not
yet fixed, you have to solder again!
Now you can remove the remaining legs with an electronic cutting pliers. The
cutting pliers has to be positioned parallel to the circuit board for not cutting
through some traces:
Finished soldering point:
Hint: Don't breath in the solder smoke and wash your hands after soldering!
http://nibo.nicai-systems.de 19