Operation Manual

Niagara SCX and Explorer Basics
14 ViewCast
Inserting a new encoder
To insert a new encoder:
1.
Go to the Insert menu and select Encoder. The system displays the New Encoder
dialog box (Figure 14).
Figure 14. New Encoder
Note: You can alternately insert an encoder by clicking on the Encoder toolbar
element; or clicking the encoder, right-clicking, and clicking Insert a New
Encoder.
2.
Click the encoder type you want to add from the Encoder drop-down list. Click OK.
3.
Click OK to save the encoder you want to connect. If you do not want to save the
encoder, click Cancel.
The new encoder with the default name New Encoder highlighted displays. The tab
changes to Auto/Name.
Figure 15. New Encoder Display
4.
Type a name for the encoder such as Encoder 1 or Main Auditorium.
5.
Press Enter to save the name change.
6.
Repeat the above steps for any additional encoders installed on this sever.