Operation Manual

-9-
Once you are satisfied with your settings, press the <ENTER> button to accept the settings.
The last setting is the selection of the video input format that you will enter into the Niagara Pro.
You will see the following prompt message.
Press the <ENTER> button to continue.
Select your video source format from either NTSC or PAL.
Press the <ENTER> button to set the format, then the final screen will appear confirming you have
successfully set up your Niagara Pro.
Press the <ENTER> button to exit the setup menu and begin using your Niagara Pro.
Configuring Niagara Pro to Connect to an IP Network
NOTE: If you are not familiar with network protocols, please contact your network administrator for
assistance.
The Niagara Pro network settings for its two 1,000 megabit network interfaces default to
dynamically obtain an IP address from a DHCP server on the network.
If a DHCP server is not available or cannot be found on the network, then Niagara Pro will assign its
own IP address.
For most network environments, it will not be necessary to modify these default settings. However,
if you wish to assign a static IP address to Niagara Pro’s Network Interface Cards (NICs), then you
can change the network setting using the Niagara Pro front panel menu.