Operation Manual

77
Control Tab
The Control Tab is used to configure the management Ethernet ports in the GOSTREAM BRD
stand-alone. This includes both the IP information, as well as the SNMP parameters. The
Control Tab is only displayed for the GOSTREAM BRD stand-alone.
The management port supports operation at 10, 100 and 1000 Mb/s, both half-duplex and full-
duplex, with auto-negotiation and auto-crossover detection.
The Control Tab has two bottom tabs:
 Control Port is used to configure the IP parameters of the control port.
 SNMP is used to configure the SNMP parameters for the unit.
Control Port Configuration Tab
The control configuration window is depicted below:
The configuration parameters are:
 Device Name: This field controls the top-level name of the device in the Dashboard tree.
It defaults to “Stand-alone Decoder”. Changes to this field take effect immediately.
 IP Configuration: This field selects the control port IP configuration mode, as follows:
o Static IP: This option selects a static IP address, specified by the IP Address,
Subnet Mask, and Default Gateway fields.