Operation Manual

70
This process is discussed in further detail in the Dashboard User Manual, chapter 5, section
Restoring Configurations to Devices.
Pre-defined Templates
The BRD offers 5 pre-defined configuration templates, as indicated below.
To load a template, just click on the Load button next to it. The pre-defined templates are;
 Decode ASI to HDMI/Composite: This template assumes a signal present in the ASI
Input, decode it, and simultaneously outputs it to the HDMI and composite ports.
 Decode ASI to SDI: This template assumes a signal present in the ASI Input, decode it,
and simultaneously outputs it to the SDI port.
 Decode UDP/RTP to SDI with 708 CC: This template assumes a multicast stream
present in the Ethernet streaming port, and decodes it to the SDI output. If the input
stream has closed-captions, these are passed through as SMPTE-334M captions.
 Decode HLS from the Internet: This template loads a public HLS feed from the
Internet and decodes it. If the decoder has access to the Internet via either the streaming
port or the control port, and is configured with a DNS address, there may be actual video
being displayed
7
.
 RTMP Server Mode: This template puts the decoder in RTMP Server Mode. It will
wait for a connection from an RTMP publishing client and display the stream.
Clear Current Configuration Button
The Clear Current Configuration button clears all the configured ports and streams as follows:
 The ASI Ports are enabled. The ASI Output is configured in automatic mode.
 The decoder is configured to decode from ASI.
 All decoder parameters are reset to their defaults.
7
Since the server is not operated by Niagara Video, we cannot guarantee that video will actually play.