Operation Manual

52
Network Tab for RTMP Client and Server
The Network Tab Statistics for the RTMP Client and Server modes is depicted below:
 Received Rate (b/s): indicates the measured rate in bits/second at the input of the
decoder.
 Stream Source IP Address: if there is an RTMP connection, it indicates the IP address
of the source. In RTMP Client mode, this is the IP address of the RTMP Server from
which the decoder is pulling the stream. In RTMP Server mode, this is the IP address of
the publishing client.
 RTMP Connection: this shows the RTMP connection state, as follows:
o Connected: The decoder has established a connection with the RTMP server
or client and is transferring data.
o Not Connected: The decoder has not been able to connect to the RTMP server,
or there is no RTMP client connected to it. If the decoder is in RTMP client mode,
check the Admin Event Log Tab for possible reasons why it is unable to connect.
Network Tab for RTSP Client
The Network Tab Statistics for the RTSP Client is depicted below:
 Received Rate (b/s): indicates the measured rate in bits/second at the input of the
decoder.
 Stream Source IP Address: if there is an RTSP connection, it indicates the IP address of
the source.
 RTSP Connection: this shows the RTSP connection state, as follows:
o Connected: The decoder has established a connection with the RTSP server
and is transferring data.
o Not Connected: The decoder has not been able to connect to the RTSP server.