Operation Manual

37
Color Bars
No additional parameters are required for Color Bars. Use the Decoder Output Configuration
controls to specify the desired output, frame rate, and other video output parameters.
Decoder Program and Audio Selection
This section is only displayed if the Source parameter in Decoder Input Configuration is set to
either ASI Input or UDP/RTP Stream. It allows the following selections to be made:
 If the stream being received by the decoder is a Multi-Program Transport Stream
(MPTS), the program to be decoded can be chosen here.
 If the program being played by the decoder has multiple audio PIDs, the audio PIDs
being decoded can be selected here.
The parameters are:
 Decoded Program, Available Programs: These two parameters work together, and are
used to select the program to be decoded in an MPTS. The program can be specified by
number in the Decoded Program field, or selected in the Available Programs drop-
down menu. If Program Auto-Select is checked, and a non-existing program number is
entered in the Decoded Program field, the decoder will ignore the setting and stay on the
current program.
 Available Programs: This control is pre-populated with a drop-down list of the
programs available in the transport stream. If the program name can be determined, it
will be shown, with the program number in parenthesis. If not, the program is shown as
Program X, where X is the actual program number. In the example below, Program 1
has a name (NBC), so it shown as “(1) NBC”, and Program 2 does not have a name, so it
is shown as Program 2.