Operation Manual

35
 Port: This field is only displayed if RTMP Port Selection is set to Specific Port.
Configure a non-standard TCP port here.
 RTMP App: Enter the application name in the server, as discussed above. Consult your
CDN or server documentation to find out what should be entered in this field.
 RTMP Server URL: This informational field is automatically updated as you configure
the RTMP parameters. It displays the full RTMP URL for the primary server.
 RTMP Stream: Enter the stream name for the server. Consult your server
documentation or CDN to find out what should be entered here. Some servers allow
arbitrary stream names, while others use this field for authentication and thus require
specific names.
 Authentication: Some RTMP servers require username/password authentication for
access. If your server does not require authentication, select No, otherwise select Yes. If
you select Yes, additional fields are presented.
 Username: Enter the username to be used for authentication.
 Password: Enter the password to be used for authentication.
RTMP Server
In RTMP Server mode, the decoder waits for a publishing RTMP client to connect to it and
publish a stream, which the decoder will then play. Please note that with the current version
of the decoder firmware, Niagara Video only guarantees compatibility with the GoStream
B264 series encoders in this mode.
The configuration parameters are as follows:
 RTMP Protocol: This is an informational field. The only supported variant is
rtmp://.
 RTMP Port Selection: If Use Default is selected, the decoder will listen on the default
RTMP Port (TCP Port 1935). If a custom, non-standard port is desired, select Specific
Port, and a new field will appear for the TCP port.