Operation Manual

30
Decoder Tab
The Decoder Configuration Tab contains the configuration parameters for the decoding function.
The Statistics tab provides quick feedback on the configuration and status of the decoding
process.
Decoder Configuration Tab
The decoder configuration tab is divided into two bottom tabs (depicted below):
 The Configuration tab, where all the main decoder parameters are configured.
 The Program Info tab, where program-specific information is displayed. If the decoder
is in HLS mode, this tab allows for manual configuration of the decoded profile.
The decoder configuration tab is divided into the following functional areas:
 The Decoder Input configuration area
 The Program and Audio Selection configuration area
 The Output Configuration area
 The Analog Audio Configuration area
 The Apply/Cancel buttons
The settings displayed in each of the areas will vary according to the specific configuration.
Decoder Input Configuration
The primary decoder input configuration parameter is the Source, which selects the input and
protocol from which the decoder will take its content:
The following stream sources are supported:
 ASI Input: the decoder will accept content on its ASI Input port.