Operation Manual

24
 IGMP Version: The GOSTREAM BRD implements the IGMP protocol for multicast
reception. This parameter controls the version of the protocol to be used.
o Auto-Detect: The BRD will attempt to auto-detect the IGMP version in use by
inspecting the Group Membership Requests received from the router. It defaults
to IGMP Version 3 if no messages are received.
o IGMP Version 1: Force the use of Version 1 only (not recommended)
o IGMP Version 2: Force the use of Version 2 only
o IGMP Version 3: Force the use of Version 3 only
 Interface speed: Configures the speed of the interface. The following modes can be
selected:
o Auto-Negotiate: The Ethernet port will auto-negotiate the speed. All modes are
available.
o 100 Mb/s Full-Duplex: Force the port to 100Mb/s Full-Duplex mode. Note that
the port will still perform auto-negotiation, but it will only advertise this mode.
o 1Gb/s Full-Duplex: restrict the operation to 1Gb/s Full-Duplex mode. Note that
the port will still perform auto-negotiation, but it will only advertise this mode.
 Interface Settings: If you make any changes to the IP Address, Subnet Mask, Default
Gateway and/or DNS fields, the Apply and Cancel buttons become active. The changes
only take effect when you press the Apply button. Pressing the Cancel button reverts the
fields back to their original values. Note that the BRD will check the consistency of the
data entered and will reject invalid combinations. Once the Apply button is pressed, a
status message appears just below the Cancel button, as follows:
Network Statistics Tab
The Network Statistics Tab reports the current IP configuration the Ethernet port, as well as its
link state and running status.