Operation Manual

88
Connections Tab
The Connections allows the creation, deletion, and management of input-output connections.
The Statistics tab includes all connected input/output status indicators and an overall summary
status indicator, which allows the operator to immediately pinpoint errors.
Connections Configuration Tab
The Connections configuration tab is depicted below. The message “No Connections” will be
displayed if there are no configured input/output connections in the B264. If the B264 has two
encoder channels installed, there will be two lower tabs, to switch between the Connections
configuration interface and the MPTS configuration/status interface.
Present only if two encoder
channels are installed
Present only if two encoder
channels are installed
To establish a connection, simply select a source and a destination, and then click on Apply.
Source Selection
There are four sources in the B264:
 Up to two Encoder channels (described in the Encoder 1, Encoder 2 Tabs section)
 Two Test Packet Generators (describe in the Admin Test Packet Generator Tab section)